Opening the lab

The D.C. Motor  / CSEC Physics
thuMb, First, seCond
All labs
A d.c. motor seen end-on: a coil between magnet poles, with the forces on each arm shown.
Magnetic field, N to S
Current in the coil arms
Force on each arm
⊙ out of page, ⊗ into page

Controls

Battery voltage6.0 V
Number of turns, N20
Magnetic field, B0.20 T
Split-ring commutator
Turn off to see why it is needed
Swap the magnets
Reverses the field instead
Try this: reverse the battery and watch the coil spin the other way. Then swap the magnets as well, and notice it goes back to the original direction.
Current, I
2.00A
Force per arm
0.32N
Turning speed
96rpm
Coil angle
0°

Apply Fleming’s Left Hand Rule

First finger
seCond finger
thuMb

Working

The motor effect

A wire carrying a current in a magnetic field experiences a force. This is the motor effect, and it is what makes a d.c. motor turn.

F = B I L

Where B is the magnetic flux density in tesla, I is the current in amperes and L is the length of wire in the field. With N turns of wire, the force is N times larger.

Fleming’s Left Hand Rule

Hold the left hand with the thumb, first finger and second finger all at right angles to one another.

  • First finger points along the Field, from N to S.
  • seCond finger points along the conventional Current, + to −.
  • thuMb then gives the Motion, the direction of the force.
Remember: Left hand for motors. The right hand rule is for generators, where motion and field give you an induced current instead.

Why the coil keeps turning

The two arms of the coil carry current in opposite directions, so the forces on them are opposite too: one arm is pushed up while the other is pushed down.

This pair of equal and opposite forces is a couple, and it produces a turning effect about the axle.

The turning effect is greatest when the coil is parallel to the field, and zero when the coil is perpendicular to it. That zero point is called the dead spot.

The split-ring commutator

Without it, the coil would turn only as far as the vertical and then the same forces would push it straight back. It would rock instead of spinning.

The split ring solves this. It is a ring cut into two halves, each connected to one end of the coil. As the coil passes through the dead spot, the two halves swap brushes, which reverses the current in the coil.

Because the current reverses at exactly the moment the coil passes the vertical, the turning effect always acts in the same rotational direction and the motor keeps spinning.

Making the motor spin faster

  • Increase the battery voltage, which increases the current.
  • Increase the number of turns on the coil.
  • Use stronger magnets, increasing B.
  • Wind the coil on a soft iron core, which concentrates the field.

All four work because they all increase the force on each arm, and therefore the turning effect on the coil.

Reversing the direction

ChangeResult
Reverse the batteryCoil spins the other way
Swap the magnetsCoil spins the other way
Do both togetherNo change, spins as before

This follows directly from Fleming’s Left Hand Rule: reversing either the field or the current flips the thumb, but reversing both flips it twice and so leaves it where it started.

Motor compared with generator

d.c. motora.c. generator
Power sourceBatteryTurning force
ConvertsElectrical to mechanicalMechanical to electrical
ComponentSplit ringSlip rings
Rule usedLeft handRight hand

Practical motors

  • Many coils set at different angles, so the motor never sits stuck on a dead spot and the turning effect is smoother.
  • Soft iron core (the armature) to concentrate the magnetic field.
  • Curved pole pieces so the field is radial, keeping the force at its maximum through more of the turn.
  • Carbon brushes, which conduct well and wear down instead of damaging the commutator.