Opening the lab

Hooke’s Law  / CSEC Physics
F = kx
All labs
A spring hanging from a support with masses on it, beside a live force against extension graph.
Extension, x
Load, F
Limit of proportionality
Elastic limit

Load the spring

Human errors
Readings carry realistic slips, like a real student’s
0
200 g masses, 0.0 N
Spring constant, k2.0 N/cm
Natural length10.0 cm
Keep the readings
Builds the results table as you load
Show energy stored
Shades the area under the graph
Try this: add masses one at a time and watch the graph build a straight line. Then grab the hanger and pull it down past the orange line, and watch the graph bend over. Go past the red line and the spring never fully recovers.
Load, F
0.0N
Extension, x
0.0cm
Total length
10.0cm
Energy stored
0.00J

Results table

Add masses to start taking readings.

Working

Hooke’s Law

The extension of a spring is directly proportional to the force stretching it, provided the limit of proportionality is not exceeded.

F = k x

F is the load in newtons, x is the extension in metres or centimetres, and k is the spring constant.

Common CSEC error: using the total length instead of the extension. Extension is always new length minus natural length, never the length itself.

The spring constant

k = F / x

k measures stiffness. A large k means a stiff spring that hardly stretches. A small k means a soft, easily stretched one.

Its units are newtons per metre (N/m), or newtons per centimetre if you keep x in cm. On a force against extension graph, k is simply the gradient.

The force against extension graph

  • Straight line through the origin while Hooke's law holds. No load, no extension.
  • Gradient = k, the spring constant.
  • Area underneath = energy stored in the spring.
  • The line bends over at the limit of proportionality, and the law no longer applies.

Plotting force on the vertical axis and extension on the horizontal is the CSEC convention, so the gradient comes out as k directly.

Must the line pass through the origin?

Yes, for the readings inside the limit of proportionality. F = kx, so F is directly proportional to x: with no load there is no extension, and zero in gives zero out.

So draw your line of best fit through (0, 0), with the points scattered a little either side of it. That scatter is human error, such as parallax when you read the pointer against the ruler.

If your line misses the origin, something is wrong. The likely cause here is a wrong starting point: a natural length measured with the hanger already on, or the total length used instead of the extension.

Two different limits

LimitWhat it means
Limit of proportionalityThe graph stops being a straight line. F = kx no longer works.
Elastic limitThe spring no longer returns to its original length when unloaded.

The elastic limit comes after the limit of proportionality. Between the two, the spring still springs back fully, but the maths is no longer a simple straight line.

Energy stored

Stretching a spring does work on it, and that work is stored as elastic potential energy. It is the area under the force against extension graph, which for a straight line is a triangle:

E = ½ F x = ½ k x²

The half appears because the force grows from zero as you stretch. Using F x on its own would assume the full force acted the whole way, which would double the answer.

The experiment

  • Hang the spring from a fixed clamp and record its natural length with no load.
  • Add masses one at a time, recording the new length each time.
  • Work out the extension for each load by subtracting the natural length.
  • Plot force against extension and draw a line of best fit through the origin.
  • Find k from the gradient, not from a single pair of readings.
Check for damage: remove the masses at the end. If the spring does not return to its original length, you went past the elastic limit and those readings are unreliable.

Springs joined together

ArrangementEffect
Two in seriesEach carries the full load, so the total extension doubles. Combined k is halved.
Two in parallelThey share the load, so each extends half as much. Combined k doubles.

Series is like a longer spring, which stretches more easily. Parallel is like a thicker one, which resists more.

Where Paper 3 asks it

His notes list Hooke’s law as set in January 2017, Paper 3, Question 1. Questions like it ask you to tabulate the load and extension, plot force against extension, find the gradient (the spring constant) and give precautions and sources of error. The Paper 3 practice tab walks through each of those.

Where it matters

  • Newton meters, which are simply a spring with a calibrated scale.
  • Vehicle suspension, absorbing bumps and storing the energy.
  • Kitchen and bathroom scales, converting extension into a mass reading.
  • Trampolines and bows, storing elastic energy and releasing it again.