Opening the lab
Light travels more slowly in glass than in air. When a ray meets a glass surface at an angle, one side of the beam slows down before the other, so the ray changes direction. This bending is called refraction.
Going from air into glass, the ray bends towards the normal, so r is smaller than i. Going from glass back into air, it bends away from the normal.
The constant is the refractive index, n, of the glass. It has no unit, because it is a ratio. Ordinary glass has n of about 1.5. This lab gives each block a hidden n between 1.45 and 1.60.
Worked example: sin i = 0.75 and sin r = 0.50 give n = 0.75 ÷ 0.50 = 1.5.
Extension, not needed for CSEC: n is also the speed of light in air divided by its speed in the glass, n = c / v. With c = 3.0 × 10⁸ m/s and n = 1.5, the speed in the glass is 2.0 × 10⁸ m/s.
Extension: for a block of thickness t, d = t sin(i − r) ÷ cos r.
With a ray from air into glass there is always a refracted ray. Since sin r = sin i ÷ n, and sin i is at most 1, r can never be bigger than about 42° for n = 1.5. Total internal reflection can only happen the other way, from glass to air, above the critical angle. This experiment never reaches it.
Snell’s law says sin i = n sin r, so sin i is directly proportional to sin r. When sin r is zero, sin i is zero too: a ray that hits the block along the normal (i = 0°) is not bent (r = 0°).
So draw your line of best fit through (0, 0), with the points scattered either side of it. That scatter is human error in reading angles. If your line misses the origin, the most likely cause is a zero error on the protractor, which adds the same small angle to every reading, or a normal that is not drawn exactly at right angles to the face.
| Precaution | Why |
|---|---|
| Pins vertical (check with a set square) | A leaning pin makes its base and its top point to different places. |
| Pins at least 6 cm apart | A longer line through two pins gives a more accurate direction. |
| Sight along the bases of the pins | The base is where the pin touches the paper. |
| Mark and label the pin positions clearly | So the right points are joined up afterwards. |
His notes give no clear Paper 3 year for this experiment, so none is claimed here. It is a standard CSEC practical, and questions on it follow the usual pattern: complete a table of sin i and sin r, plot a graph, find the gradient, and give precautions and sources of error. The Paper 3 practice tab walks through each of those.
About this lab: it is a model. Snell’s law is exact here, and the scatter of about 1° in the protractor reading is a chosen value, not measured from a real protractor.