Opening the lab

Magnetic Field of a Conductor  / CSEC Physics
thumb = current, fingers = field
All labs
Close the switch to begin
A circuit with a battery connected to a straight vertical conductor. Flipping the terminals reverses the current and the magnetic field around the wire. BATTERY SWITCH looking down the wire from above ? ?
Conventional current
Anticlockwise field
Clockwise field
Plotting compass

Controls

Power
Switch closed
Live motion
Flowing
Try this: drag the white and blue handle anywhere along the highlighted wire, top wire, conductor, or bottom wire. The whole field pattern follows it, so you can inspect the field at any point in the circuit, not just one fixed spot.

Applying the grip rule

The right-hand grip rule

current (thumb) field (fingers curl)

Point your right thumb in the direction of conventional current. Curl your fingers as if gripping the wire. Your fingers curl the same way the magnetic field circles the conductor.

thumb → current, fingers → field

This is also called Maxwell's corkscrew rule: a corkscrew driven in the direction of the current turns the same way as the field.

Dot and cross notation

Since a page cannot show a wire coming toward you, physics uses two symbols for current perpendicular to the page:

  • ⊙ (dot) means current is flowing out of the page, toward you.
  • ⊗ (cross) means current is flowing into the page, away from you.

In the diagram above, the field pattern is drawn as if you are looking straight down the wire from above. Current flowing up toward you is the dot case; current flowing down away from you is the cross case.

Reading the result

Think of a clock face: current flowing into the face makes the field wrap clockwise. Current flowing out of the face, toward you, makes it wrap anticlockwise.

  • Out of the page (dot) → field is anticlockwise
  • Into the page (cross) → field is clockwise

Reverse the current and the field reverses with it. That is exactly what flipping the terminals does in the demonstration.

Plotting compasses in the lab

The CSEC practical for this topic passes a wire through a horizontal card and places small plotting compasses on the card around it. With no current, every needle points north.

Close the switch, and each needle swings to point tangent to a circle around the wire, all pointing the same rotational way. That is the compass ring shown in the demonstration above.

Note: field strength decreases with distance from the wire. Compasses further out deflect less, which is why the outer field ring is drawn fainter than the inner one.

Not to be confused with Fleming's rules

This grip rule finds the field created by a current. It is a completely different question from Fleming's Left and Right Hand rules, which find the force on a conductor that is already sitting inside someone else's magnetic field.

  • Grip rule: current in → field out. Used for wires, solenoids, electromagnets.
  • Fleming's Left Hand: field and current in → force out. Used for motors.
  • Fleming's Right Hand: field and motion in → induced current out. Used for generators.

A CSEC question that gives you a field pattern and asks for the current is the grip rule. One that gives you a field and a moving wire and asks for a force or an induced current is Fleming's.

Beyond one wire: the solenoid

Coil the wire into a loop and the fields from each turn add up inside the coil, giving a much stronger, more useful field, the basis of every electromagnet.

The rule adapts: curl the fingers of your right hand in the direction the current flows around the loops, and your thumb points to the coil's north pole.

Reverse the current in a solenoid the same way as here, by swapping the terminals, and its north and south poles swap too. This is exactly how a relay or an electromagnetic crane is switched on and off.