Opening the lab

Refraction & Total Internal Reflection  / CSEC Physics
n₁ sin θ₁ = n₂ sin θ₂
All labs
A light ray meeting the boundary between two media, showing the normal, the angle of incidence, and the refracted and reflected rays. NORMAL
Incident ray
Refracted ray
Reflected ray
Critical angle

Set up the boundary

Angle of incidence, θ₁ 30°
Show reflected ray
Some always happens: faint at small angles, stronger at large ones
Jump to a standard case
Try this: set glass into air, then drag the angle up slowly. Watch the refracted ray flatten toward the boundary, then vanish the moment you pass the critical angle.
Incidence θ₁
30.0°
Refraction θ₂
19.2°
Critical angle
none
Speed in med. 2
1.97×10⁸

Working

The laws of refraction

  • The incident ray, the refracted ray and the normal at the point of incidence all lie in the same plane.
  • Snell's law: the ratio of sin i to sin r is constant for a given pair of media.
n₁ sin θ₁ = n₂ sin θ₂

Angles are always measured from the normal, never from the surface.

Which way does it bend?

  • Entering a denser medium (higher n): light slows down and bends toward the normal.
  • Entering a less dense medium (lower n): light speeds up and bends away from the normal.
  • Travelling along the normal (0 degrees): no bending at all, though the speed still changes.
Common CSEC error: measuring the angle from the surface instead of the normal. If a question gives you an angle to the surface, subtract it from 90 first.

Refractive index

n = sin i / sin r

For light going from air into a medium. More generally, the refractive index compares the speed of light in the two media:

n = c₁ / c₂ = λ₁ / λ₂

The frequency never changes when light crosses a boundary. Only its speed and wavelength change, which is why it bends.

The critical angle

sin c = n₂ / n₁

When light travels from air into a medium, this simplifies to the form you will usually see in CSEC:

sin c = 1 / n

At the critical angle, the refracted ray travels exactly along the boundary, at 90 degrees to the normal.

Total internal reflection

TIR happens when both conditions are met:

  • Light is travelling from a denser medium into a less dense one.
  • The angle of incidence is greater than the critical angle.

Beyond that angle no light escapes at all. It is all reflected back, obeying the ordinary law of reflection.

Note: TIR is impossible going into a denser medium. There is no critical angle in that direction, at any angle of incidence.

Typical refractive indices

MediumnCritical angle to air
Air1.00none
Ice1.3149.8°
Water1.3348.8°
Perspex1.4942.2°
Crown glass1.5241.1°
Diamond2.4224.4°

Diamond's very small critical angle traps light inside through many internal reflections, which is what gives it its sparkle.

Where TIR is used

  • Optical fibres. Light bounces along the core by repeated TIR, carrying internet and phone data.
  • Endoscopes. Fibre bundles let doctors see inside the body.
  • Prismatic periscopes and binoculars. 45 degree prisms turn light through 90 degrees with no loss.
  • Reflectors on roads and bicycles. Corner prisms send light straight back to its source.

Everyday refraction

  • A straw looks bent in a glass of water, because light from the submerged part bends as it leaves.
  • A pool looks shallower than it is. Real depth is greater than apparent depth by a factor of n.
  • Mirages form when hot air near the ground has a lower refractive index, bending light upward.
  • A coin reappears when you pour water into a cup, because refraction bends the light over the rim.