Opening the lab
The two arms of the coil always feel equal and opposite forces, so together they make a couple that turns the coil. But the turning effect depends on the angle:
turning effect ∝ cos θWith an ordinary continuous ring, the current in the coil never changes direction. So once the coil passes the vertical, each arm is on the opposite side of the field but still carrying current the same way.
By Fleming's Left Hand Rule the force on each arm is unchanged, but the arm has moved to the other side of the axle. The same force now produces a turning effect the other way round.
The coil swings back. It rocks about the dead spot and, with any friction at all, settles there and stops.
The commutator is a ring cut into two halves, each connected to one end of the coil. The brushes press against it but stay still.
As the coil turns, the gap between the halves sweeps past the brushes. At that instant each half swaps to the other brush, which reverses the current through the coil.
Switching there has two advantages, and both matter:
Switch anywhere else and the motor would either lose drive or jerk violently.
Over a full turn, the numbers make the point sharply.
| Average turning effect | |
|---|---|
| No commutator | Zero. Forwards half the time, backwards the other half, cancelling exactly. |
| Split ring | About 64% of peak. A steady forward push every moment of every turn. |
A motor with no commutator has no net driving effect at all, no matter how strong the magnets or how large the current.
Even with a split ring, a single coil still passes through the dead spot twice a turn, where the turning effect briefly drops to zero. Start it there and it will not move at all.
Real motors use several coils set at different angles, each with its own pair of commutator segments. They never all reach a dead spot together, so:
| Split ring | Slip rings | |
|---|---|---|
| Shape | One ring cut in two | Two separate full rings |
| Does it reverse the current? | Yes, every half turn | No, never |
| Used in | d.c. motor | a.c. generator |
| Purpose | Keep it turning one way | Let the current alternate |
A generator wants the alternating output, so it uses slip rings that never swap over. A motor wants steady rotation, so it needs the split ring.
If asked to explain the purpose of the split ring commutator, a full answer says all three of these: